WALL MOUNT
For Milky Way, WiFi & Rainbow models

1. Place the Atelier’s Nespresso® Dispenser in the desired location, away from excessive heat or cold.
2. Hold the dispenser in the desired location and place a level on top of it to ensure it is straight.
3. Mark the where to drill the holes by inserting a pencil and marking a dot into the 4 corner holes of the piece.
4. Drill over the pencil marks and place the plastic anchors inside.
5. Manually affix the enclosed screws. Do not use a power tool since there is a risk of cracking the acrylic.
6. Place the magnets over the screws when they are in place, to provide a finished look for the piece.

 

COUNTER STAND
For Milky Way, WiFi & Rainbow models

1. Place the front and back of the unit together.
2. Screw in the screw posts on its top holes.
3. Screw in the shanks on the bottom holes.
4. Place away from excessive cold or heat.

 

ADHESIVE WALL MOUNT
For Smiley model

1. Place the front and back of the unit together.
2. Screw in the screw posts on its three holes.
3. Place away from excessive cold or heat.
4. Peel off the adhesive’s protective strip and affix it to a clean, flat surface.

 

REPLACEMENT PARTS
If spare parts are needed, please check out our accessories page for precise replacements.

Back to Homepage

ON SALE

Start the day with a smiley.

  • Our new model can display up to 10 capsules, and features an adhesive back wall mount

Featured products

A constellation of flavors.

  • Accommodates up to 40 capsules
  • Available in both wall mount and counter stand options

NEW PRODUCTS

Fun and connected.

  • Accommodates up to 30 capsules
  • Available in both wall mount and counter stand options

FEATURED PRODUCTS

A rainbow of options!

  • Accommodating up to 20 capsules
  • Available in both wall mount and counter stand options